A grandfather clock that stops usually tells you why if you look in the right order: the weights, the level of the case, the beat of the pendulum and the hands. Most of these can be checked in ten minutes without tools.
Find the likely cause
Answer the questions; every path is also listed below.
See every path
Where is the left-hand (time) weight?
- Near the bottom → Wind it up. If the clock is cable-driven, crank slowly and don't let the weight hit the movement at the top.
- High up
Does the pendulum swing freely and keep swinging?
- Stops after a few minutes
Is the tick-tock even?
- Even → Look at the hands: if they touch each other or the dial, free them. If not, the movement needs a clockmaker.
- Uneven → Level the case side to side, then set the beat by easing the crutch gently, or call a clockmaker if you aren't comfortable.
- Doesn't swing at all → Check that the pendulum is hooked on the suspension spring and goes through the crutch, and that it doesn't touch the weights.
- Swings for hours, then stops → The movement is short of power, typical of old oil and wear. Book a service.
- Stops after a few minutes
Read the weights
A typical Westminster grandfather clock has three weights. Seen from the front, the left one drives the time, the middle one the hourly strike and the right one the quarter chimes. The right weight is often the heaviest.
- Left weight at the bottom: the clock simply ran down. Wind it.
- All weights high, clock stopped: the problem is the pendulum, level, beat or the movement.
- One weight falling much faster than the others: that train is running when it shouldn't, or a cable has slipped.
- A weight swapped onto the wrong hook: clocks may stop or chime oddly. Weights are often marked L, C and R underneath.
Level and beat
Grandfather clocks are tall, so a small slope at the floor becomes a big one at the movement. Check level side to side on the case top and adjust the leveling feet or shim the base. Then listen to the beat. If it limps after leveling, the crutch needs setting. Many modern movements have a self-adjusting beat: swinging the pendulum firmly to one side resets it.
The pendulum and suspension spring
Open the lower door and look at the top of the pendulum rod. It hangs from a thin flat spring (the suspension spring). If that spring is bent or cracked, the pendulum wobbles or twists and the clock stops. Replacement springs are inexpensive, but fitting one requires removing the pendulum carefully; a clockmaker can do it on a house call.
Cable problems
On cable-driven clocks, the cable must wind neatly in the grooves of its drum. A cable that crossed over itself or jumped off a pulley can jam the clock or snap. If you see a cable off its pulley or wound unevenly, stop winding that side and call a clockmaker.
Questions
Why did my grandfather clock stop ticking?
The most common reasons are a run-down time weight, a case that isn't level, a clock out of beat, a pendulum not hooked properly or a movement that needs cleaning.
Why does my grandfather clock work only when the pendulum is removed?
Without the pendulum the escapement runs free, which shows the movement has power. If it stops once the pendulum is on, check the beat, the suspension spring and whether the pendulum rubs anything.
How long should a grandfather clock run after winding?
Most modern grandfather clocks are eight-day clocks and are wound once a week. Some older clocks are 30-hour clocks and need daily winding.
