Chimes & strike

Grandfather clock not chiming or chiming wrong

Updated October 2026 ยท ChronoCrafter editorial teamTroubleshooting
Quick answer

A silent chime is often a setting, not a fault. Check the chime selector and the night shut-off before anything else. Chimes that play at the wrong time, or an hour count that doesn't match the hands, usually mean the hands and the strike have drifted apart, which is often fixable without opening the case.

If it doesn't chime at all

  • Silent setting. Many dials have a lever or a small dial marked Silent / Chime, or a selector such as Westminster / Whittington / St. Michael's. A lever left between two positions can silence the clock.
  • Night shut-off. Some movements stop chiming automatically overnight (roughly 10pm to 7am). If the hands were set by turning back, the shut-off can be twelve hours out and the clock is silent all day.
  • Chime weight. The right-hand weight drives the chimes. If it is at the bottom, wind it.
  • Hammers and rods. Check that the hammers haven't been pushed away from the rods or tubes, for example after a move.

If it strikes the wrong hour

When the clock strikes, for example, seven while the hour hand points at three, the hour hand has moved independently. Wait until the strike has finished, then gently move only the hour hand (it is a friction fit on most clocks) to the hour that was struck. Then set the correct time with the minute hand, letting the clock chime each quarter as you go.

Advertisement

If it chimes at the wrong time

The full Westminster chime should play when the minute hand is exactly on 12. If it plays at, say, five past, the minute hand has slipped on its arbor. On many clocks the minute hand is held by a small nut or a collet: holding the hand, the clockmaker (or a confident owner) moves it on its square so it points to 12 when the hour chime starts. If the chime sequence plays the wrong quarter, let the clock run through the quarters, or ask a clockmaker to re-synchronise it.

Chimes slow, sluggish or stopping mid-tune

A chime train that drags or stops midway needs cleaning and oiling. The chime is the hardest-working part of the movement, so it is usually the first to show wear. See service intervals.

Questions

Can I turn the hands backwards on a chiming clock?

On most modern movements it's safer to move the minute hand forward only, pausing at each quarter to let the chime finish. Some movements tolerate turning back; check the manual.

Why does my grandfather clock chime the wrong number of times?

The hour hand has moved out of step with the strike. Move just the hour hand to match the number struck, then set the time again.

Related

Find clock repair near you

Compare clockmakers by state and city, with the clocks they work on and whether they make house calls.