A grandfather clock is regulated by the length of its pendulum. Lower the bob and the clock runs slower; raise it and it runs faster. Small turns of the rating nut under the bob are all it takes, but give the clock a full day between adjustments.
Regulating step by step
- Set the clock to the correct time and note the time exactly 24 hours later.
- Stop the pendulum gently. Find the rating nut under the pendulum bob.
- Running slow: turn the nut to raise the bob. Running fast: turn it to lower the bob.
- Start the pendulum, reset the time and check again after another 24 hours.
On many grandfather clocks one full turn of the nut changes the rate by roughly a minute a day, but this varies with the pendulum length and the thread. The calculator below gives a starting point.
Regulation calculator
One full turn of the rating nut changes many grandfather clocks by about a minute a day; if your manual gives a different figure, enter it. Adjust, wait 24 hours, measure again.
When regulation doesn't help
- The rate changes a lot from day to day: the beat or the pendulum is unsteady, or the movement is losing power.
- It runs well for a few days after winding and then slows: power loss as the weights fall, typical of a movement that needs cleaning.
- The nut is already at the end of its thread: someone may have fitted the wrong pendulum or suspension spring.
Small effects that are normal
Temperature changes the length of a pendulum rod slightly, so a clock may run a little differently in summer and winter. Opening the door often or a draft across the pendulum can also make a small difference. A mechanical clock that keeps within a minute or so a week is doing well.
Questions
Which way do I turn the nut to make a grandfather clock faster?
Turn the rating nut so the bob moves up. Owner's manuals usually describe this as turning the nut to the right as you face the clock, but watch the bob to be sure it is rising.
Why does my grandfather clock gain time?
The pendulum is effectively too short. Lower the bob a little with the rating nut and check again after 24 hours.
